Lightly Used Carbide End Mills 1/16″ 2-Flute Square End Up Cut 50 Pieces UMT114

Description

Lightly used, cleaned and inspected.

When gently used will do, save big over new. For a fraction of the cost, perfect for hobby or light industrial use.

Two Spiral Flutes- cuts many materials including:

Metals: Steel, aluminum, brass & copper.

Wood: Hard and softwood

Plastics:Acrylic, PVC, polycarbonate, and nylon

Composites:Fiberglass and carbon fiber composite

Up Cut Flutes – Forces chip evacuation upward, maximizing surface quality

Square EndPlunge Tips -For through panel cuts or pocket milling.

Spiral two flute carbide end mills are commonly used to cut a wide range of materials, including:

1. Metals: They are effective in cutting metals such as steel, aluminum, brass, and copper. These end mills offer good chip evacuation and can handle high cutting speeds.

2. Wood: Spiral two flute carbide end mills are suitable for cutting various types of wood, including hardwood and softwood. They provide smooth and clean cuts, reducing the chances of splintering.

3. Plastics: These end mills are also capable of cutting different types of plastics, such as acrylic, PVC, polycarbonate, and nylon. The sharp cutting edges and flute design help in achieving precise cuts and minimizing melting or chipping.

4. Composites: Materials like fiberglass and carbon fiber composites can be effectively cut using spiral two flute carbide end mills. The sharp cutting edges and flute geometry assist in maintaining the integrity of the composite materials.

It is important to note that the specific performance and suitability of the end mills may vary depending on factors such as the composition, thickness, and hardness of the material being cut.